Baxall IP Series Operations Instructions download pdf (Page 11)

Page 11

Installation and Operating Instructions IP Series Codec

SERIAL PORT CONNECTIONS

RS422 (4-wire) Network Connection and Biasing/Termination Details

Note that the switch settings for all END units are the same, and for all MID units.

CONFIGURATION SWITCHES

Each channel of the IP Codec contains two rows of eight DIP switches. The basic function of the dip switches is described

below.

Video Mode Switches

This switch allows you to select the video standard (PAL or NTSC) of the connected video source or monitor. The factory

default setting is for PAL.

Config Switches

These switches are used in conjunction with the configuration software and allow you to select whether the IP Codec

functions as an Encoder or as a Decoder. The switches route the video signals to the VID4 BNC connector allowing a

common connector to be used as either an input or an output. Note, however, that the correct software must be installed

and the switches set correctly for each unit to operate.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Baxall IP Series Operations Instructions Page 11